FEP fluoroplastic film

FEP fluoroplastic film

1. FEP film features:

1. Non-stick and thermal sealing with F46,

2. Below the melting point, not wetting with any object.

3. It has good adhesion with F4 and metals. Its own adhesion (heat seal) to high and low temperature-200--200 ° C;

4, Non -sticky, waterproof, fight oil;

5, Water contact angle θ = 114о;

6, Electricity reliability, high insulation;

7, With below high and low temperature 60Hz-60MHz the dielectric constant is always 2.1. Even if the surface is damaged due to diving, conductive tracks will not be produced.

8, Volume resistance> 1018Ωm;

9, Surface resistance> 2*1013Ω;

10, Arc resistance> 165 seconds without leakage;

11, High transparency ultraviolet rays and visible light have good penetration; they have the lowest refraction coefficient compared to other plastic.

2. FEP film application

Adhesive, Iron bottom plate, Lacquer cloth ring, Conveyor belt bond the head, Adhesive layer in the middle of the copper plate, Dan Kai F4 plate melt welding film, Release film, the window, Electric body, High temperature sticky belt substrate, Capacitor, Biological Deep Cold Protection Materials, Hot Power Plant, etc. Use non -metal compensators, explosion -proof motors, and surface protection materials.